TThis comprehensive ASME B31.3 Process Piping Learning Path consisting of two courses trains participants on the requirements of the ASME B31.3 Code, including design, analysis, materials, fabrication, testing and inspection of process piping systems. With real-world industry best practices, it also helps participants prevent piping failures and provides deep insight into the relationship
Course Bundle - Piping Components and Piping Valves for The course starts with basic topics of piping components and moves toward the advanced concept. Initial sections cover fundamentals piping and role of piping components in piping. You will also get acquainted with industrial code, Standard, and Specification.
ISO - Pipe, Tube and Fittings Standards and SpecificationsRelated Topics . Codes and Standards - Piping codes and standards - ASME, ANSI, ASTM, AGA, API, AWWA, BS, ISO, DIN and more..; Related Documents . ASTM D2661 - Acrylonitrile-Butadiene-Styrene (ABS) Schedule 40 Plastic Drain, Waste, and Vent Pipe and Fittings - Nominal pipe size, outside diameter, thickness and weight; Comparing American and British Piping Standards - Comparing US
NM.1 - Thermoplastic Piping Systems - ASMEDescription. ASME NM.1 provides requirements for the design, materials, manufacturing, fabrication, installation, inspection, examination and testing of thermoplastic pressure piping systems. The standard addresses both pipe and piping components that are produced as standard products and custom products that are designed for a specific application.
SMLS pipe is supplied according to ASTM Specifications A53, A106, A333, A312, A358, etc., and API 5L pipe Sizes:1/8 (3.175 mm) nominal to 26 (660.4 mm) OD. Less than 2 3/8 (60.325 mm) OD is known as pressure tubing that has different dimensional standards (wall thickness and diameter).
Specifying pipe and piping materials - ConsultingWhen specifying piping for a large campus project, designers/engineers must be intentional when editing the associated specifications sections (ARCOM MasterSpec sections 23 21 13.23 and 23 21 13.13, respectively, for above- and below-grade hydronic piping) to be certain that the piping specified for the tower and podium are reflective of their
The American Society of Mechanical Engineers - ASMEASME (American Society of Mechanical Engineers) promotes the art, science & practice of multidisciplinary engineering around the globe.
According to the US pipeline specifications, natural gas pipeline injection typically contains CO 2, water vapour, H 2 S and O 2 at less than 3%, 112 mg/m 3, 350 mg/m 3 and 1 ppm, respectively. Low concentration of water vapour and H 2 S is essential to avoid condensation and corrosion.